Certified SKF technical service from TD IRBIS
TD IRBIS LLC is a certified SKF partner under the CMP program
TD IRBIS carries out maintenance, diagnostics and condition monitoring of industrial equipment in line with SKF standards and methods. Certified partner status under the CMP program confirms the qualification of the company's specialists, the use of professional diagnostic equipment and the compliance of service work with the manufacturer's requirements.
TD IRBIS specialists are trained and certified by SKF to perform vibration diagnostics, laser alignment, balancing and the introduction of equipment condition monitoring systems. Technical support is provided both for individual production units and for complex industrial facilities.
The core approach of TD IRBIS and SKF is to act ahead of possible equipment failures. Regular condition monitoring makes it possible to detect defects at an early stage, plan repairs before emergency stops occur and reduce the risk of unplanned production downtime.
SKF CMP maintenance program: main principles and benefits
SKF CMP (Certified Maintenance Partner) is SKF's international certification program for service partners in the maintenance and diagnostics of industrial equipment. The program sets requirements for staff qualification, work methods, the use of diagnostic equipment and quality control of service support.
The main principle of the CMP program is to predict and prevent possible equipment defects before critical damage or emergency failures occur. For this purpose, vibration diagnostics, condition monitoring and analysis of equipment operating parameters are used.
Maintenance under the SKF CMP program makes it possible to:
- detect defects in bearings, drive units and mechanical transmissions in good time;
- monitor the condition of equipment without stopping production processes;
- reduce vibration loads and the risk of premature wear of units;
- cut emergency repair costs;
- extend the service life and reliability of equipment;
- plan maintenance based on the actual condition of machines.
Requires technical review by an engineer: "monitor the condition of equipment without stopping production processes" - it must be clarified whether this applies to all types of work and equipment.
Work included in the SKF certified maintenance program
Within the SKF certified maintenance program, TD IRBIS performs diagnostics, condition monitoring, alignment, balancing and the introduction of monitoring systems for industrial equipment.
- Data collection using vibration measuring equipment.
- Analysis of the technical condition of equipment.
- Alignment of drive components using laser technology.
- Geometric measurements using laser technology.
- Balancing of rotors of machines and equipment.
- Diagnostics of the technical condition of machines and systems (checking bearings, mechanical transmissions, the electromagnetic system and flow parts) using spectral analysis, envelope acceleration methods and high-frequency recording.
- Description of the nature of damage, identifying defects in bearings, mechanical transmissions, the flow part and the electromagnetic system. Recommendations on replacing components.
- Demonstration of the possibilities for remedying faults.
- Installation and commissioning of devices supported by electronic data processing for monitoring equipment condition.
- Inspection and performance of the work required for the equipment to be serviced.
-
Installation of monitoring products and devices.
- Training. Joint work with specialists of enterprises' diagnostic services, training in the use of diagnostic equipment, and selection of the optimal equipment configuration for monitoring, diagnostics, alignment and balancing tasks.
Maintenance by TD Irbis under the SKF CMP program makes it possible to detect changes in the technical condition of equipment in good time, minimize the risk of emergency failures and keep production processes running steadily.